Text-Only Instructions
Credits and Resources:
Design and instruction via Whatsapp: Nishi Sakpal - Mumbai, India
Text-Only Instructions: Lindy van der Merwe, Cape Town, South Africa
Copyright 2024 by Lindy van der Merwe and Nishi Sakpal
As you might gather from the title of this model, it is derived from
MDL0039 - ORIGAMI - 2D OR FLAT LANTERN.
Paper to be used: Square, any size; use large paper to practice with at first;
If you would like for your chair or chairs to be smaller than your table, experiment with the sizes of your starting squares.
Folding level: Easy/Beginner
Steps: 10
Description: This is a 3D chair. It has a square seat and a fairly low rectangular backrest with rectangles on the 3 remaining sides, forming solid panels or "legs", making it quite sturdy as origami furniture goes.
Instructions:
Note: If you know how to fold the square table (MBFF011), you can create a table and then go to Step 10.
Step 1
Fold the 2D or Flat Lantern - MDL0039, by going to the link below.
MDL0039 - ORIGAMI - 2D LANTERN
Step 2
Place your lantern so the unfolded triangles of the model are at the left and right.
Step 3
As you did for the top and bottom parts of the lantern, turn the side triangles into rectangles as well.
So, gently open the left and right triangles and squash them down so they look the same as the top and bottom rectangles of the lantern.
Step 4
Flip the model over from left to right.
Step 5
Starting with the side nearest you, fold the entire edge over to the center of the model.
Use your thumbs to find the edge of the rectangle underneath the model.
Make the fold so the entire rectangle becomes visible as you fold it over to the center.
The long side of the rectangle will now form the outside of the square along this first edge.
Step 6
Turn the model 90 degrees to the right so you can work with the next edge.
Note that the second rectangle will fold over on top of the first, so don't worry about how thick the layers become.
Step 7
Repeat the previous 2 steps until all 4 sides are folded inwards.
You will have a square of many layers now.
Step 8
Now, gently unfold each rectangle, but only until it is standing straight up, facing the ceiling, or at a 90 degree angle in relation to the folding surface.
Make sure the rectangles are all straight and reinforce the creases along all 4 sides.
Step 9
Lastly, flip over the model so you have a table (MBFF011).
Step 10
To form the back of your chair, take the leg of the table furthest away from you and bring it, with a valley fold upwards, towards you until it is standing straight up.
It should be at a 90 degree angle or slightly more, in relation to the flat surface, which will become the seat of your chair.
Reinforce the crease and you will be able to admire your chair, a beautiful, but also very useful piece of origami furniture.
Making origami accessible through text instructions.
For non-commercial use only.
Compiled: November 2023
This text copyright 2024 by accessorigami.com
Comments
Post a Comment